Shandong plastic floor and Shandong flax floor belong to elastic floor, but what is the difference between them?
Composition and production process are different: Flax flooring is a mixture of oxidized flaxseed oil, cork and wood powder, laminated onto the jute backing. The plastic floor is made of polyvinyl chloride and its copolymer resin as the main raw materials, fillers, plasticizers, stabilizers, colorants and other auxiliary materials, on the continuous sheet substrate, by coating process or calendering, extrusion or extrusion process. From this point of view, flax is made of pure natural flax, while plastic floor is made of polyvinyl chloride, but it is also a green environmental protection material.
Wear resistance and stability are different: Shandong flax flooring has a general scratch resistance, flax flooring is hard and soft, which is why the thick flax flooring scratch resistance is not very good, compared with plastic flooring, the wear resistance is better. In addition, the dimensional stability of flax flooring is general, so it is necessary to use strong glue. On the whole, the stability of flax flooring is not as good as that of plastic flooring.
The degree of maintenance is different: flax floors need to be maintained under natural light, samples and objects will be different, yellowing, flax floors for maintenance products (PH > 7) resistance is poor, flax floors in need of re-polishing, waxing must use special maintenance products. Flax flooring is much harder than plastic flooring, but because the surface is porous, all stains must be removed quickly, otherwise the surface will leave imprints that are difficult to remove and have to be polished and waxed again. Because it is not a thermoplastic material, so it can not be recycled, scalded marks can be easily worn off, but for deeper scalded marks, the penetrating plastic floor is much easier to polish than flax floor.
Installation difficulty is different: it is difficult to install flax flooring, if the indoor temperature is too low, flax flooring will break. Because of its absorption nature and dimensional instability, the product must be quickly installed with strong glue. For example, in a day, an installation team can lay 80 to 100-inch plastic floors, or maybe only 60-inch flax floors. Flax oil is insensitive to temperature and can not be welded with welding rods of the same material, so it is not welded but "seam", so flax floor can not be divided into E3 waterproof type, flax floor is not suitable for wet rooms or areas with clean requirements. Flax floors emit a strong odor and remain in the installed room.
More information about Senran Plastic Flooring can be consulted by clicking on our official website: http://www.hghreleaserreview.com/